R2Photogram Components & Setup

R2Photogram Components

Please check the table to see if the parts are complete before the installation of the Photogrammetry Camera. Purchase and use a scan body and scan cap that are suitable for the abutment you are using. If the individual content does not match and you cannot install the system, please contact the MegaGen Digital team for support.

1) Camera: The camera's 3D information is reconstructed from 2D images taken by the camera. The camera is mainly composed of optical and imaging systems.

2) USB cable: It is used to transmit the output signal from the camera host to the computer, and connect the camera host and the computer.

3) U disk (including software): Used to transmit the output signal from the Camera. 3D acquisition software in U disk: It is used to transmit output signals from the camera to the computer, connecting the camera and the computer.

4) Charger: Charge the camera and provide a stable power supply.

5) Tripod: Used for camera support and stable shooting. Note: For stability of the tripod, please place it on a stable tabletop.

CAUTION: The Photogrammetry Camera is integrated with the Power Adapter and cannot be replaced at will.

6) Scan Body: The function of the Scan body is mainly used in conjunction with the camera to locate the position and direction of the implant, and through camera calculations, form 3D data.

WARNING: > A) The Scan Body shall be used for no more than 10 times; B) The Scan Body is damaged or deformed and cannot be used;

7) Scan Cap: Scan Cap uses a 3D scanner to determine the location of implants in the mouth. It replaces the existing impression method by enabling impression work using electronic devices, and supports production using scanning data in a CAD program when producing an upper prosthesis using CAD/CAM equipment.